Blind base cabinets are a variation of your average base cabinet that offers additional storage hidden in a corner. Despite how strange they may look; they go together just like any other cabinet and you should have them finished in just 5 simple steps.
How to Assemble a Blind Base Cabinet - In 5 Easy Steps
Blind base cabinets are an alternative to other corner cabinets like easy reaches or Lazy Susan’s. They offer static storage that some people prefer to the slightly more complicated corner cabinets. In addition, blind base cabinets feature a drawer, unlike other corner cabinets. Just like any other cabinet, you’ll need a few tools to get the job done. A mallet, Phillips head screwdriver, box cutter, and some glue will be necessary for assembling this cabinet. “Don’t forget to save your box and use it to protect your cabinets! And shop your RTA cabinets wholesale direct if you still need some.
In this post, you will learn:
- How to assemble blind base cabinets
- What tools you will need to assemble RTA cabinets
- How long it takes to put together RTA cabinets
- How easy it is to put together RTA cabinets
1.
Assembling the Cabinet Box
Similarly to how you would normally assemble base cabinets, start by laying your face frame face down on your work surface and inserting a line of glue into all of the dado joints. Insert the right-side panel into the dado on the face frame and secure it to the face frame with two L-brackets. Do the same for the left panel.
Slide the bottom panel into the two dados on the side panels and attach it to the face frame using the L-bracket you just attached. To add some additional support, secure the side panels to the bottom panel using and L-bracket from each. Add four more L-brackets to the inside of the side panels under the exposed dado joint at the pre-drilled locations.
2.
Installing the Back Panel and Toe Kick
Once the brackets are in place, slide the back panel into the dado joints, tapping with a rubber mallet to ensure the panel is seated properly. The back panel can then be secured to the side panels using L-brackets. The back panel should also be attached to the bottom panel using two screws through the back of the back panel.
Flip the cabinet over so that it lays flat on its back and attach two L-brackets to each of the side panels on the inside where the toe kick will go. Set the toe kick board into place and attach it from the underside to the L-brackets.
3.
Assembling the Drawer Box
Insert a bead of glue into all of the female dovetail joints before inserting the male portions of the joint into the drawer face piece. Tap each joint with a mallet to ensure that it is seated firmly before sliding the bottom panel into the dado joints in each of the side pieces. Once the bottom panel is in place you may attach the back panel, again, tapping with a mallet until the joints are flush.
4.
Installing the Drawer Box
To begin installing your drawer box, attach the left and right clips to the drawer box at the front near the drawer face. They can easily be attached with three screws each. Next, located the pre-drilled holes on the face frame and install your drawer glides, making sure that the glides are fully extended before installing. Please note that the glides do not extend to the back panel. For this particular cabinet. Now all that is left is to simply slide your drawers onto the glides until they clip in.
5.
Installing the Door
Installing your door is incredibly simple. Start by attaching the hinges to the door using two screws per hinge. The cup side of the hinge will be inserted into the cup slots on the door. Once again, locate the pre-drilled holes on the face frame of the cabinet and screw the other side of each hinge to the face frame. To protect your cabinet face frame, be sure to put some bumper pads on the corners of your cabinet door.